Operation - Rinnai RB-63SSV-DL Installation Manual

Control Knob
o The control knob is used to ignite the burner and to regulate the strength of the flame.
The burners can only be in operation mode by pressing down the
appropriate control and turning it anti-clockwise, and switched off by
turning the control clockwise.
The following will cause damage to the appliance:
o Operating the burner without pressing the control down,
o Operating the burner on by turning the control clockwise,
The manufacturer will not accept liability for any damage resulting from
incorrect operation.
Operating
o The control for the burner required must be pressed down and turned anti-clockwise to
the large flame symbol in order to operate.
Pressing a burner control will automatically create a spark on
all burners. This is normal and no cause for concern
o When the flame ignites, hold the control knob down for 5 seconds, and then let it go.
o If the flame goes out, turn the control back to "o". Wait for at least 1 minute before
attempting to re-ignite it, press down and hold the control for longer if required
o If the burner fail to ignite for the second time, turn the control back to "o". Refer to the
troubleshooting guide for more information.
The gas supply is turned off
High Flame
Low Flame

Operation

16