Rinnai RB-63SSV-DL Installation Manual page 9

o Do not store or use corrosive chemicals, steamers, flammable materials or non-food
products below or near this domestic appliance.
o If the appliance has not been used for a long period of time it should be thoroughly
cleaned before it is used again. It is also advisable to have the appliance tested for
safety
o If a cooker hood is installed above the gas hob, ensure that the burners are always
covered with a pan when in use. Otherwise flames could reach the cooker hood, parts of
which could then be damaged or set on fire.
o Do not flambé under a cooker hood. The flames could set the cooker hood on fire.
o Do not use the appliance as a resting place for anything else. The article could melt or
catch fire if residual heat is still present or if the appliance is switched on by mistake.
o Do not cover the appliance, e.g. with a cloth, kitchen foil, etc. This could be a fire hazard
if residual heat is still present or the appliance is switched on by mistake.
o Do not uses plastic or aluminium foil containers. These melt at high temperatures and
could catch fire.
o Do not heat up unopened tins of food on the hob as pressure will build up in the tin,
causing it to explode. This could result in injury and scalding or damage.
o Make sure all the components of the gas burners have been correctly assembled before
switching on.
o Pans must be the correct size for the burner they are used on (see "Suitable pans"). A
pan which is too small will be unstable on the pan support. If the pan diameter is too
large, flames can spread out to the sides and damage or burn the worktop, wall
claddings or surrounding units and also parts of the hob
o Before connecting the appliance to the mains electricity supply, make sure that the data
quoted on the data plate match the household mains supply, otherwise the appliance
could be damaged. Consult a qualified electrician if in any doubt.
o If the appliance is supplied without a plug, or if the plug is removed, it must be connected
to the mains electricity supply by a suitably qualified and competent electrician in strict
accordance with current local safety regulations. The manufacturer cannot be held liable
for damage caused by incorrect installation or connection.
o Connection to the gas supply must be carried out by a suitably qualified and competent
person in strict accordance with current local safety regulations
Safety Instructions
7