Rinnai RB-63SSV-DL Installation Manual page 15

Gas Connection (Fig. 3)
The end of the inlet connection point of the gas hob has a 1/2" thread that allows for:
o Fixed connection.
o Connection using a flexible hose (For LPG only). In this case, it is necessary to insert the
accessory and the O-Ring as shown in Fig. 3. In this case, you must prevent the pipe
from coming into contact with moving parts of the kitchen unit being inserted (for
example, a drawer) and prevent access to any spaces which might become obstructed.
Warning! If any connection is handled, check for gas leakage. The manufacturer is not liable
for any connection leaking, after being handled.
Electric Connection (Fig 4)
Check that the voltage and power of the appliance are compatible with the electrical
installation. The hobs are supplied with a power cable with or without a wall socket plug.
Provide an omnipolar cut-off switch with a minimum contact separation of 3 mm (except for
plug connections, if the user has access to it).
Appliances with plugs must only be connected to sockets that have earth wires correctly
installed.
The supply cable can only be changed by your local Rinnai customer care centre and not the
user. The cable type and minimum cross-section must be respected.
Installation Guide
13