Table of Contents
Advertisement
Installation
All operations relating to installation, regulation and conversion to other types of gas
must be carried out by an authorised installation personnel, respecting applicable
regulations, standards and the specifications of the gas and electricity providers.
Before you begin, turn off the appliance's electricity and gas supply.
You are recommended to contact your local Rinnai Customer Care Centres to convert
to another type of gas.
The units next to the appliance must be made of non-flammable materials. The laminated
covering and glue for adhering it must be heat resistant.
This appliance cannot be installed above fridges, washing machines, and dish washer or
similar.
An oven must have a power cooling fan to install a hob above it. Check the oven's
dimensions in its installation manual.
If a cooker hood is installed, you must follow the installation manual's instructions, always
keeping a minimum distance of 550 mm to the hob.
Preparing the Bench Top (Fig 1 & Fig 2)
Make an appropriate size cut in the work surface.
It is recommendable to place a non-flammable separator (e.g. metal or plywood) 10 mm
from the bottom of the hob. This will prevent access to the base of the hob.
On wood work surfaces, varnish the cutting surfaces with a special glue. This protects them
from moisture which could collect under the work surface.
Installation of Appliance
The adhesive seal (underside of the hob) are factory-fitted: do not under any circumstances
remove them. The seal ensures that the entire work surface will be watertight, and prevents
water seepage.
In order to fit the appliance into the kitchen unit, first place the hob in the correct position.
Insert and centre the hob. Press the sides of the hob until it is supported around its entire
perimeter.
Removal of Hob
1) Turn off incoming gas
2) Remove gas hose
3) Life the hob up.
Installation Guide
10
Advertisement
Table of Contents
