Rinnai RB-63SSV-DL Installation Manual page 23

Cleaning
Cleaning
Stainless Steel Clean stainless steel surfaces with a
Surface solution of warm water and a little washing-
up liquid applied with a soft sponge.
If necessary, you could use the scouring
pad on the reverse of a washing-up
sponge. Apply with an even pressure
following the direction of the "grain".
Pan supports Remove the pan supports. Clean the pan
supports using a solution of warm water
and a little washing-up liquid applied with a
soft sponge.
If necessary, you could use the scouring
pad on the reverse of a washing-up
sponge
Controls Clean the controls with a solution of warm
water and a little washing-up liquid applied
with a soft sponge.
Burner caps, Clean the burner caps with a solution of
Burner Base warm water and a little washing-up liquid
and Burner applied with a soft sponge.
Ring
If necessary, you could use the scouring
pad on the reverse of a washing-up
sponge.
Ignitor, Flame The Ignitor and ignition safety devices
Safety Device should be very carefully wiped clean using
a dry cloth.
Cleaning and Care
Instructions
Printed surfaces
(Flame symbols)
Remove any soiling which comes into contact with the
printed flame symbols straight away. Soiling,
particularly salty food or liquid and olive oil, can cause
damage if left on the printed surfaces for a long time.
Do not use stainless steel cleaning agents on the
printed flame symbols. This would rub off the print.
Stubborn soiling should be soaked first. The pan
supports are not dishwasher proof.
The controls are not dishwasher proof.
The burner caps are not dishwasher proof.
Make sure that the flame slits are completely dry after
cleaning.
Do not let the ignitor get wet. If they get wet they will
not spark.
21