Getting Started with the Base Reference Design Demonstration
X-Ref Target - Figure 1-6
Ethernet
Cable
DVI to VGA
Adapter
Setting the CF Configuration Mode
The Base Reference Design is located in the CompactFlash memory card. To select the CF
configuration, set DIP switch (SW1) so that both M0 and M1 are in the OFF position, as
shown in
Now set the System ACE™ CF Image Select DIP switch (S1) to 1101 where switches 1, 2,
and 4 are set to the ON position and switch 3 is set to the OFF position, as shown in
Figure
Setting switches 1 and 2 to the ON position selects configuration slot 3, where the Base
Reference Design demonstration is located.
X-Ref Target - Figure 1-7
12
CompactFlash Card and
System ACE CF Controller
Figure 1-6: Connecting Cables and CF Card
Figure
1-7.
1-7. Setting switch 4 to the ON position enables the System ACE CF controller.
S1
Figure 1-7: Setting the Mode Select and System ACE CF Select Switches
www.xilinx.com
SW1
Spartan-6/SP605 Getting Started Guide
UG525 (v1.3) March 29, 2011
Power On
Switch
12V
Power
J18
UG525_06_101910
UG525_07_101910