How To Turn On And Turn Off The Océ Tds300 - Oce TDS300 User Manual

How to turn on and turn off the Océ
TDS300
To turn on the system:
turn on the printer.
■
turn on the scanner (see page 43).
■
turn on the controller (see page 17)
■
When you turn on the system, it is ready for operation.
If the system is not in use for more than 90 seconds, the operator panel returns
automatically to the stand-by mode. The operator panel of the scanner is
activated in the following conditions:
you feed an original
■
a key on the operator panel is pressed
■
▼
Turn on the printer
Set the ON/OFF switch at the rear of the printer to position '1' (see figure 3).
1
[3] On/off switch of the printer
When 'Ready' is displayed on the operator panel, the printer is ready for
Note:
use.
Set the ON/OFF switch at the rear of the printer to position '0' (see figure 3).
1
If you switch off the printer during a print job, it is possible that you lose
2
information or that a paper jam occurs.
16 Océ TDS300 User Manual