Storing The Machine; Handling And Transportation; Assistance And Repairs; Warranty Coverage - Stiga 7 Series Operator's Manual

9. STORING THE MACHINE

IMPORTANT The safety regulations to
follow for putting into storage are described
in paragraph 2.4. Strictly comply with these
instructions to avoid serious risks or hazards.
If you are not going to use the machine
for a period of more than 2-3 months, we
recommend you do a few things before putting
it away. This will make it easier when you
want to use the machine again and will also
prevent permanent damage to the engine.
Before putting the machine away:
1. Unscrew the two clutch housing nuts, remove
the housing and remove the chain and bar.
2. Empty the oil tank, fill with about 100-120 cc
of specific liquid detergent and plug the cap.
3. Fit the guard back on without
tightening the nuts.
4. Start the engine and keep it running
until all detergent is used.
5. Start the engine and run it idle until
it uses up all the fuel that is left in
the tank and the carburettor.
6. Wait for the engine to cool.
7. Remove the spark plug.
8. Pour a teaspoon of (new) 2-stroke
engine oil into the spark plug slot.
9. Pull the starter hand grip several
times to deliver oil to the cylinder.
10. Replace the spark plug with the
piston in the dead end upper position
(visible from the spark plug slot when
the piston is at maximum stroke).
11. Clean the machine thoroughly.
12. Check the machine for any
damage. If necessary, contact the
Authorised Service Centre.
13. Store the machine:
– in a dry place
– protected from inclement weather
– with the bar cover guard fitted correctly
– in a place where children cannot get to it
– making sure that keys or tools used
for maintenance are removed.
Before starting to use the machine again:
1. Remove the spark plug.
2. Pull the starter hand grip a few
times to eliminate excess oil.
3. Check the spark plug (par. 8.5).
4. Arrange the machine (par. 4.2 chap. 6)

10. HANDLING AND TRANSPORTATION

When handling or transporting
the machine, always:
– stop the machine (par. 6.6).
– wait until the chain is stationary.
– remove the spark plug cap (Fig. 31.A).
– mount the bar cover.
– only hold the machine using the hand
grips and position the bar in the opposite
direction to that used during operation.
When transporting the machine
on a vehicle, always:
– position it so that it does not
cause a hazard to anyone;
– fasten firmly to the means of transport using
ropes or chains to prevent it from tipping
over causing damage and fuel leaks.

11. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorized Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorized
centres or by unqualified persons will
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only authorized service centres or
dealers can carry out guaranteed
repairs and maintenance.
• The authorized service centres or dealers
only use genuine spare parts. Genuine
spare parts and attachments have been
designed specifically for machines.
• Non-genuine spare parts and attachments
are not approved. Use of non-genuine
spare parts and attachments cause
the warranty to be invalidated.
• It is advisable to send your machine
once a year to an authorized service
centre or dealer for servicing, assistance
and safety device inspection.

12. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
EN - 17