Garmin GPSMAP 5215 Owner's Manual page 50

Gpsmap 4000 series; gpsmap 5000 series
Hide thumbs Also See for GPSMAP 5215:
Table of Contents

Advertisement

Almanac, Environmental, and On-boat Data
Wind Angle Data
Viewing the Wind Angle Data Graph
The chartplotter must be connected to the peripheral devices listed below to capture the data shown on the
wind speed graph.
Wind Angle
Description
Apparent Wind Shows wind direction data based on the flow
of air experienced while on a boat in motion�
This is the Apparent Wind Angle, which is
calculated in reference to the bow of the boat,
and is represented in degrees port or degrees
starboard�
True Wind
Shows wind direction data based on the
flow of air experienced while on a stationary
boat� This is the True Wind Angle, which is
calculated in reference to the bow of the boat,
and is represented in degrees port or degrees
starboard� For the most-accurate data, the
Wind Speed Source setting should be set to
Auto
(page
Ground Wind
Shows wind direction data based on the flow
of air experienced while on shore� This is
the Ground Wind Angle, which is calculated
in reference to north, and is represented in
degrees clockwise� North can be true north,
magnetic north, or grid north, depending upon
the configuration of the Heading reference
setting
1. From the Home screen, select information > Graphs > Wind Angle.
2. Select the type of wind direction data included on the graph (Apparent Wind, true Wind, or Ground
Wind).
Air and Water Temperature Data
Viewing the Air and Water Temperature Graph
The chartplotter must be connected to a water-temperature sensor or a temperature-capable transducer
to capture the data shown on the water temperature graph. The chartplotter must be connected to an air-
temperature sensor to capture the data shown on the air temperature graph.
If you have turned on and configured the water temperature alarm
temperature data that is 2°F (1.1°C) above or below the temperature specified for the alarm.
1. From the Home screen, select information > Graphs > temperature.
2. Select the type of temperature information included on the graph (Air temp or Water temp).
Atmospheric Pressure Data
Viewing the Atmospheric Pressure Graph
The chartplotter must be connected to a barometric-pressure sensor to capture the data shown on the
atmospheric pressure graph.
From the Home screen, select information > Graphs > Atmo. Pressure.
Depth Data
Viewing the Depth Graph
The chartplotter must be connected to a depth-capable transducer to capture the data shown on the depth
graph.
From the Home screen, select information > Graphs > Depth.
If you have turned on and configured the shallow water and deep water alarms
in red any water depth data that is less than the depth specified for the shallow water alarm, and it shows in
red any water depth data that is greater than the depth specified for the deep water alarm.
46
52)�
(page
54)�
Required Sensors
A wind sensor�
A wind sensor and a speed sensor; or a wind
sensor and a GPS antenna�
A wind sensor, a water-speed sensor, a
heading sensor, and a GPS antenna; or a
wind sensor and a GPS antenna; or a wind
sensor, a water-speed sensor, and a heading
sensor�
(page
94), the graph shows in red any water
(page
GPSMAP
4000/5000 Series Owner's Manual
®
94), the graph shows

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents