Heart Rate Monitor And Gsc 10 Batteries - Garmin Edge 800 Owner's Manual

Appendix
3. Plug the small end of the AC
charger into the mini-USB port.
To connect the device to your
computer using the USB cable, see
page 21.
4. Charge the device completely.
A fully charged battery can run for up
to 15 hours before it must be recharged.
Heart rate Monitor and
gSC 10 Batteries
wArNINg

Do not use a sharp object to remove
user-replaceable batteries.
CAUTION

Contact your local waste disposal
department to properly recycle the
batteries. Perchlorate Material – special
handling may apply. See
.ca.gov/hazardouswaste/perchlorate.
48
www.dtsc
replacing the Heart rate
Monitor Battery
1. Use a small Phillips screwdriver to
remove the four screws on the back
of the module.
2. Remove the cover and battery.
3. Wait 30 seconds.
4. Insert the new battery with the
positive side facing up.
NOTE: Do not damage or lose the
O-ring gasket.
5. Replace the back cover and the four
screws.
After you replace the heart rate monitor
battery, you must pair it with the device
again (page 13).
Edge 800 Owner's Manual