Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Garmin 605
Summary of Contents for Garmin 605
- Page 1 EdgE 605/705 ® gPS-ENABLEd BIKE COMPUTER...
- Page 2 Warning: This product contains a lithium-ion battery. See the Important Safety and Product Information guide in the product box for important battery safety information. Warning: Always consult your physician before you begin or modify any exercise program. See the Important Safety and Product Information guide in the product box for product warnings and other important information.
-
Page 3: Resetting The Edge
➍ thumb stick/enter • Move the thumb stick to scroll through menus, options, and data fields. • Press in the thumb stick to select options and to acknowledge messages. ➎ start/stop Press to start/stop the timer. ➏ menu • Press to open the menu page. •... -
Page 4: Step 2: Install The Edge
Step 1: Charge the Battery You can charge the Edge using the AC charger or the USB cable and your computer. note: To prevent corrosion, thoroughly dry the mini-USB port, weather cap, and surrounding area before charging or connecting to a personal computer. - Page 5 be used under the mount for a better viewing angle. To install the Edge on your bike stem: 1. Place the wedge on the bike stem, and then place the bike mount on the wedge. Make sure the release lever is on the left. Release lever Bike mount...
-
Page 6: Step 3: Turn On Your Edge
4. Slide the Edge to the left until it snaps into place. To release the Edge: Press down on the release lever, and slide the Edge to the right. Step 3: Turn on Your Edge Press and hold to turn on your Edge. -
Page 7: Heart Rate Monitor
4. Turn on the Edge and bring it within range (3 m) of the heart rate monitor. The icon appears on the menu page. Heart Rate Monitor Strap Heart Rate Monitor (Front) Sensors Heart Rate Monitor (Back) note: The Garmin logo should be right-side up. heart rate... - Page 8 GSC 10 Both magnets must be aligned with their respective indication lines for the Edge to receive data. To install the GSC 10: 1. Place the GSC 10 on the rear chain stay (on the side opposite the drive train). Loosely attach the GSC 10 using two cable ties.
- Page 9 GSC 10 Pedal magnet not enough room between the sensor arm and the spoke. The magnet must be aligned with the sensor arm indication line. 4. Loosen the screw on the sensor arm and move it to within 5 mm of the spoke magnet.
-
Page 10: Step 8: Go For A Ride
6. When everything is aligned and working correctly, tighten the cable ties, sensor arm, and spoke magnet. Step 7: Set Your Set Your Profiles The Edge uses information that you enter about yourself and your bike to calculate accurate ride data. To set your user profile: menu Settings... -
Page 11: Step 9: Download Free Software
Edge (under the weather cap). 2. Connect the larger end of the USB cable to an available USB port on your computer. 3. Open Garmin Connect or Garmin Training Center. Follow the upload instructions included with the software. More Information... - Page 12 © 2007 Garmin Ltd. or its subsidiaries Garmin is a trademark of Garmin Ltd. or its subsidiaries, registered in the USA and other ® countries. Garmin Training Center , Edge , Garmin Connect , GSC 10, Dynastream , ANT ®...