(page ™ 6. Go for a ride (page 7. Save your ride (page Edge 800 Quick Start Manual 8. Get Garmin Connect 9. Transfer history to your computer about the Battery This product contains a lithium-ion the first time, ®...
(shown on 1. Select a secure location to mount ➊ the Edge where it does not interfere with the safe operation of your ➋ bike. page 3) or the handlebars. Edge 800 Quick Start Manual...
➋. 5. Align the tabs on the back of the Edge with the bike mount notches ➌. Edge 800 Quick Start Manual 6. Press down slightly and turn the on the back ➊ Edge clockwise until it locks into place.
Page 6
Press to view the status page and adjust the backlight. Press to create a new lap. Press and hold to save your ride and reset the timer. Press to start and stop the timer. Edge 800 Quick Start Manual...
Using the Backlight At any time, tap the touchscreen to turn on the backlight. Edge 800 Quick Start Manual Locating Satellite Signals It may take 30–60 seconds to locate satellite signals. 1. Go outdoors to an open area.
Page 8
1. Place the GSC 10 on the rear chain stay (on the side opposite the drive train). NOTE: Place the flat rubber pad or the triangle-shaped rubber pad between the GSC 10 and the chain stay for stability. Edge 800 Quick Start Manual appears ➊...
Page 9
➎ magnet must line up with the indication line on the GSC 10. ➏ Edge 800 Quick Start Manual ➌ 4. Unscrew the spoke magnet the plastic piece. ➒ to the ➌ 5. Place the spoke in the groove of the plastic piece, and tighten it slightly.
Page 10
Garmin recommends that the torque is 1.9 to 2.4 lbf-in to ensure a water tight seal on the GSC 10 sensor arm. appear solid on Edge 800 Quick Start Manual...
History is recorded only while the timer is running. 2. After completing your ride, press STOP. Edge 800 Quick Start Manual Saving Your ride Data Press and hold RESET to save (page 5) or your ride data and reset the timer.
3. Click Send to Device. 4. Disconnect the Edge, and turn it on. 5. Select MENU > Courses. 6. Select the course > Go. ➊ Locations You can record and store locations in ➋ the device. Edge 800 Quick Start Manual...
4. Select (page 5. Select a data field to change it. For a complete list of the available data fields, see the Edge 800 Owner’s Manual. Edge Temperature readings You can customize the Edge to display temperature in a data field.
1. Press The status page appears. 2. Select Lock. Training with Power Meters • See the Edge 800 Owner’s Manual, for more information. • Go to www.garmin.com/intosports for a list of third-party ANT+ sensors that are compatible with the Edge.
• Go to http://my.garmin.com. • Keep the original sales receipt, or a photocopy, in a safe place. Edge 800 Quick Start Manual Contacting Garmin Product Support You can contact Garmin Product Support if you have any questions about this product.