Customizing Projector Features; Remote Monitoring Setup Options; Miscellaneous Setup Options; Enabling Sleep Mode - Epson PowerLite 835p User Manual

note
When Standby Mode is set
to , the
Network ON
exhaust fan continues to
operate after the projector
has cooled down. This is
normal.
Fine-Tuning the Projector
134

Customizing Projector Features

You can use the menu system to turn Standby Mode on or off, adjust
the network settings, select the projection mode, change the language,
and turn Sleep Mode on or off.

Remote Monitoring Setup Options

These options let you set up the projector so it can be monitored and
controlled from a remote computer (see page 138).
(in the Extended menu)
■ Standby Mode
Select
Network ON
a network when it's in standby mode.
If you want to monitor the projector using a network
■
management utility, select
enter at least one trap IP address.

Miscellaneous Setup Options

(in the Extended menu)
■ Projection
Select (to project from the front of a screen and right side
Front
up),
Front/Ceiling
from the ceiling),
Rear
transparent screen), or
a transparent screen when the projector is mounted upside-down
from the ceiling).
(in the Extended menu)
■ Language
Select from nine languages to be used for the projector menus.

Enabling Sleep Mode

In Sleep Mode, the projector automatically turns off the lamp when it
has not received any signals for 30 minutes. This conserves electricity,
cools the projector, and extends the life of the lamp. When you want
to start projecting again, just press the P
In the Extended menu, select
or .
ON OFF
to enable the projector to be monitored over
in the Network menu and
SNMP
(when the projector is mounted upside-down
(to project from behind onto a
(to project from behind onto
Rear/Ceiling
Power
,
Operation Sleep Mode
button.
, and choose