Epson PowerLite 735c User Manual page 42

note
For specific details about
your network, please consult
your network administrator.
note
If you don't know your
gateway or access point
address, see page 41.
Presenting Through a Wireless Network
36
6. If your access point assigns IP addresses automatically, turn on
. Otherwise, turn off DHCP and enter the following
DHCP
information manually:
: Type in the IP address you want to assign to the
IP address
projector. It must be formatted like other addresses on the
network; usually the first three numbers (XXX.XXX.XXX)
match the access point's IP address.
Subnet mask
on how your network is set up.
Gateway address
the access point when it was set up.
7. If a higher level of data-transmission security is desired, enter a
as provided by your network or IT administrator.
WEP Key
8. If you want to create a password for remote access to the
projector, type it in the box next to
and press .
Enter
9. If you want to set up a security keyword so that only people who
are in the same room as the projector can access it, turn
on. Then when you want to connect to the projector, it
keyword
displays a randomized four-digit number or "keyword" on the
screen. When prompted by NS Connection, you can enter the
keyword on your computer to connect (see page 43).
10. If you want to monitor the projector using HP OpenView,
you'll need to enter at least one trap IP addresses. See Chapter 7
for details on monitoring the projector.
11. When done making these settings, highlight the
top of the screen (you can either use the arrow buttons on the
remote control or press
Highlight the
OK
main EasyMP Network Screen.
: For example: 255.255.255.000, but depends
: Enter the IP address that was assigned to
Password for WEB control
to highlight it), then press
ESC
button again and press
Projector
™
button at the
OK
.
Enter
to return to the
Enter