Table of Contents
Advertisement
fully charged. Charge the batteries only using the DECT Handset charger
supplied with the handset.
Attention: Use a CPC N0162957 charger if you have a DECT 4027 or
Charging guidelines
Observe the following when you charge your handset:
•
•
•
•
Get user manuals:
See SafeManuals.com
4070 Handset, and a CPC N0206072 charger if you have a
DECT 4075 Handset.
Charge the battery for at least 6 hours before you use the handset for
the first time. This protective measure extends the service life of the
batteries.
Note: The batteries attain maximum power output only after several
charging and discharging cycles.
Do not leave the handset inserted into the charger for more than 30
days without using it.
You can charge and discharge the batteries hundreds of times, but
eventually they wear out. If the operating time (talk and standby time)
becomes significantly shorter than usual, replace the batteries.
To maintain optimum operating time, periodically discharge the
batteries by leaving the handset off the charger and switched on, until
the handset switches itself off. Use only this method to discharge the
batteries. If you want to accelerate the discharge of the battery, you
can enable the display. For more information about configuring power
save, see
"Configuring power save" (page
Note: Extreme temperatures influence the charging capability of the
batteries.
Getting started
186).
23
Advertisement
Table of Contents
