Lcd Panel Safety Instructions - Epson Stylus Photo RX600 User Manual

Be careful when you handle used ink cartridges; there may be ink remaining
around the ink supply port. If ink gets on your skin, wash it off with soap and
water. If it gets in your eyes, flush them immediately with water.
Do not put your hand inside the Stylus Photo RX600 or touch the cartridge
during printing.
Don't move the print head by hand; you may damage the printer.
Don't shake cartridges after you remove them from their packages; this might
cause leakage.
Install the ink cartridge immediately after you remove it from its package.
Leaving the cartridge unpacked for a long time before use may result in
reduced print quality.
Don't use a cartridge beyond the date printed on the cartridge package. For
best results, use up the ink cartridges within six months of installing them.
Store ink cartridges in a cool, dark place. Store each ink cartridge so that the
bottom of its package faces down.
After bringing an ink cartridge inside from a cold storage site, allow it to warm
up at room temperature for at least three hours before using it.
Do not remove or tear the label on an ink cartridge; this can cause leakage.
Don't dismantle cartridges or refill them; you could damage the print head.
Do not touch the green IC chip on the side of the cartridge. This may affect
normal operation and printing.
If you remove an ink cartridge for later use, protect the ink supply area from
dirt and store it in the same environment as the Stylus Photo RX600. There is
a valve in the ink supply port, making covers or plugs unnecessary, but care is
needed to prevent the ink from staining items that the cartridge touches. Do
not touch the ink cartridge ink supply port or surrounding area.

LCD Panel Safety Instructions

Use only a dry soft cloth to clean the LCD display. Don't use liquid or
chemical cleaners.
If the LCD display is damaged, contact your dealer.
If LCD solution gets on your skin, wash it off thoroughly with soap and
water. If it gets in your eyes, flush them immediately with water.
162
Requirements and Notices