Printing A Nozzle Check; Problems And Solutions; Setup And Software Installation Problems - Epson Stylus Photo RX600 User Manual

Printing a Nozzle Check

You can print a nozzle check to determine whether a problem comes from the
Stylus Photo RX600 or some other source.
1. Make sure letter-size or larger paper is loaded in the sheet feeder.
2. Press the
3. Press the d button to select
4. Press the
5. Press the
If the check page prints, the problem probably lies in your software settings, the
interface cable, or your computer.
If the check page doesn't print, you may have a problem with your Stylus Photo
RX600. Try the suggestions in the following sections.

Problems and Solutions

Check the solutions below if you're having trouble using your RX600.

Setup and Software Installation Problems

Tip:
It's a good idea to check Epson's web site periodically for possible updates to your
software. Visit http://support.epson.com and check the section for your product to see if
there is new software available for downloading to your computer.
The Stylus Photo RX600 makes noise after ink cartridge installation.
When you install ink cartridges, the Stylus Photo RX600 must charge its ink
delivery system. Wait until it's finished (the
from the RX600 screen) before you turn it off, or it may use excess ink the
next time you turn it on.
Make sure the ink cartridges are seated securely and no packing material
remains in the Stylus Photo RX600. Turn off the Stylus Photo RX600, wait a
moment, then turn it back on.
142
Solving Problems
button on the control panel to enter setup mode.
Setup
button.
OK
button again. The nozzle check prints.
OK
.
Nozzle Check
Charging
message disappears