Wolf M Series Design Manual page 43

Induction Cooktops
Induction Cooktops
ELEMENT RATING
60 cm COOKTOP
279 mm
203 mm
203 mm
76 cm COOKTOP
279 mm
203 mm
203 mm
152 mm
91 cm COOKTOP
279 mm
(2) 203 mm
(2) 203 mm
Planning Information
A minimum height clearance of 159 mm is required from
the top of the countertop to any combustible surface
W
directly below the cooktop.
2600 / 3150 boost
2100 / 3000 boost
Contemporary Induction Cooktops can be mounted flush
2100
with the top of the countertop, or as a frameless standard
installation sitting on top of the countertop surface. If the
W
2600 / 3150 boost cooktop is to be mounted flush with the countertop, a
2100 / 3000 boost
recessed area surrounding the cooktop cutout must be
2100
provided.
1400
IMPORTANT NOTE: Flush mount installations are intended
W
for granite, solid surface, or stone countertop surfaces
2600 / 3700 boost
only.
2100 / 3000 boost
2100
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
Locate the electrical supply as shown in the illustrations on
the following pages. A separate circuit servicing only this
appliance is required.
Performance may be compromised if the electrical supply
is less than 220 volts.
The cooktop is supplied with a single phase and 3-phase
convertible power inlet box.
ELECTRICAL REQUIREMENTS
ELECTRICAL SUPPLY
Single Phase
3-Phase
TOTAL AMPS
60 cm Cooktop
76 cm Cooktop
91 cm Cooktop
220–240 V AC, 50/60 Hz
380–415 V AC, 50 Hz
SINGLE PHASE 3-PHASE
30 16
32 16
48 16
subzero.com | 43