Wolf M Series Design Manual page 33

Speed Ovens
Planning Information
The Speed Oven can be installed in a standard or flush
inset application.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
For flush inset installations, a minimum 3 mm reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
If the Speed Oven is installed above or below a Wolf E
Series Oven in a flush inset application, a 6 mm reveal is
required.
INSTALLATION REQUIREMENTS
BASE SUPPORT
60 cm Model
76 cm Model
TRIM OVERLAP
Top
Bottom
Sides
57 kg
57 kg
60 cm MODEL 76 cm MODEL
5 mm 5 mm
0 mm 0 mm
18 mm 98 mm
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
Locate the electrical supply as shown in the illustrations
on the following pages. A separate circuit servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
Performance may be compromised if the electrical supply
is less than 220 volts.
ELECTRICAL REQUIREMENTS
Electrical Supply
Service
MIN
Receptacle
Power Cord
220-240 V AC, 50 Hz
2800 W
grounding-type (earthed)
1.2 m
subzero.com | 33