Epson AcuLaser M7000N series User Manual page 92

Epson AcuLaser M7000 Series User's Guide
A controller error or a print engine error has been detected. Turn off the printer. Wait at least 5
seconds, then turn it back on. If the error message still appears, write down the error number listed on
the LCD panel (Cffff/Exxx), turn off the printer, unplug the power cord, then contact a qualified
service representative.
Set MP Tray
This message indicates that the MP tray is not correctly installed in the printer. Reinstall or Install the
MP tray appropriately.
Sleep
The printer is currently in the power-save mode. This mode is canceled when the printer receives print
data.
Toner Low
This message indicates that the imaging cartridge is near the end of its service life. Prepare a new
imaging cartridge.
Transfer Unit Needed Soon
This message indicates that the transfer unit is near the end of its service life. You can continue to print
until the Replace Tranasfer Unit message appears.
Turn Paper MP Tray/ Turn Paper Cassette1/ Turn Paper Cassette2/ Turn Paper Cassette3
The direction of the paper loaded in the MP Tray or the specified paper cassette does not match the
required paper direction. Turn the paper direction to landscape.
Unable Clear Error
The printer cannot clear an error message because the error status still remains. Try solving the
problem again.
Warming Up
The printer is warming up the fuser to be ready to print.
Write Error ROM P
This message indicates an internal error in the printer. Reset the printer. If this error persists, consult
your dealer.
Using the Control Panel 92