Customizing The Power Frequency Setting - Polycom CX5100 User Manual

User's Guide for Polycom CX5100 Unified Communication Station
Network Configuration Settings
Setting
Default Gateway
Subnet Mask
Preferred DNS Server
Alternate DNS Server
Enable EAP/802.1x
EAP Identity
EAP Password
3 Do one of the following:
 Click Apply to Device to push the new configuration file onto your CX5100 system. Enter the
system password if prompted.
When the changes is complete, a dialog box appears. It may take up to a minute for the the new
network connection to be ready for use.
 Click Save to PC to save the settings to a profile on your computer. You can specify where to save
the profile.

Customizing the Power Frequency Setting

In most cases, the system defaults to the correct power line frequency, based on the video standard used
in the country where the system is located. This setting allows you to adapt the system in areas where the
power line frequency does not match the video standard used. You might need to change this setting to
avoid flicker from the fluorescent lights in your conference room.
To change the power frequency:
1 From the CX5100 - CX5500 Control Panel, click Configuration and then click Advanced.
2 Choose the power frequency used in your location. In most cases, you can use the factory setting.
3 Do one of the following:
 Click Apply to Device to push the new configuration file onto your CX5100 system. Enter the
system password if prompted.
 Click Save to PC to save the settings to a profile on your computer. You can specify where to save
the profile.
Polycom, Inc.
Description
Displays the gateway currently assigned to the system. If the system does not
automatically obtain a gateway IP address, enter one here.
Displays the subnet mask currently assigned to the system.
If the system does not automatically obtain a subnet mask, enter one here.
Displays the DNS server to which the system attempts to register.
Displays the DNS server to which the system attempts to register if registering to the
preferred DNS server is not successful.
Enables the System to use 802.1X authentication. You must Enter the Host Name,
Domain Name, EAP Identity, and the EAP passwords manually.
Indicates the system's EAP ID. This setting is required in order to save or apply a
profile.
Indicates the system's EAP password. This setting is required in order to save or apply
a profile.
Customizing Your System
17