Transport, Storage And Disposal - Stiga T 92 Series Quick Manual For Use

1. Place the machine on a flat, solid surface.
2. Connect a water hose to one of the two specific couplings
(Fig. 27) and open the water supply.
3. Sit in the driver's seat, put the transmission in neutral ("N")
and start the machine.
4. Fully lower the cutting means and engage the cutting
means.
5. Let the water flow for a few minutes and then stop the
machine.
6. Turn off the water supply and disconnect the hose from
the coupling.
7. Repeat the procedure on the other coupling.
8. Blow a jet of compressed air over the upper part of the
assembly (Fig. 28).
6.4. BATTERY
Carefully read and observe the battery recharging instructions
in the booklet provided with the battery. Failure in following
the procedure or in charging the battery could permanently
damage the battery elements. A flat battery must be recharged
as soon as possible.
Recharging must be done using a battery
IMPORTANT
charger at constant voltage. Other recharging systems can irre-
versibly damage the battery.
The machine comes with a connector (Fig. 29) for recharging;
this is connected to the corresponding connector for the
special maintenance battery charger supplied (if available)
or available on request.
IMPORTANT This connector must only be used for con-
nection to the maintenance battery charger indicated by the
Manufacturer. For its use:
- follow the instructions given in the relative instruction manual;
- follow the instructions in the battery manual.
6.5. CUTTING MEANS MAINTENANCE
Do not touch the cutting means until the ignition
key has been removed and the cutting means is
completely stationary. Be careful that the cutting
means can move, even if the key has been removed
(for battery-powered models).
All work on the cutting means (disassembly,
sharpening, balancing, repairing, reassembly
and/or replacing) are demanding jobs that require
special skills as well as special tools; For safety
reasons, these jobs are best carried out at a
Authorised Service Centre.
Always replace damaged, bent or worn cutting
means, together with their nuts and bolts, in order
to ensure they remain balanced.
IMPORTANT Always use original cutting means bearing the
code indicated in the "Technical Data" table.
7. TRANSPORT, STORAGE AND
DISPOSAL
7.1. TRANSPORT
When handling the machine, always:
1. disengage the cutting means;
2. bring the cutting means assembly to the highest position;
3. switch off the machine and remove the ignition key
4. disengage the drive (par.4).
When transporting the machine on a vehicle or trailer, always:
• use an access ramp of suitable strength, width and length;
• load the machine with the engine switched off, with the key
removed from the ignition, without a driver and pushed by
an adequate number of people;
• close the fuel tap (if provided);
• lower the cutting means assembly;
• position it so that it does not cause a hazard to anyone;
• engage the drive (par.4);
• lock it firmly on the means of transport using ropes or
chains to prevent it from tipping over and possible damage.
7.2. STORAGE
When you intend to put your machine away for more than
30 days:
• Wait for the engine to cool
• Disconnect the battery cables and store it in a cool and
dry place.
• Empty the fuel tank and follow all the instructions in the
engine manual.
• Clean the machine thoroughly.
• Check the machine for any damage. If necessary, contact
the authorised service centre.
Store the machine:
• with the cutting means assembly lowered;
• in a dry place;
• protected from inclement weather;
• covered with a sheet if possible;
• in a place out of children's reach;
• making sure that keys or tools used for maintenance are
removed.
Before starting to use the machine again:
• check that there are no fuel leaks from the tubes, fuel
stopcock or carburettor:
• prepare the machine as described in chapter "5 Use of
the machine".
NOTE Ensure that the battery is fully charged at least once a
month and always before use.
NOTE Store the machine so as to avoid any risk in the event
of accidental contact with people, children or animals.
EN - 10