Related Manuals for Dimplex DHPH20F
Summary of Contents for Dimplex DHPH20F
- Page 1 INSTRUCTION MANUAL 1.8kW Panel Heater Model: DHPH20F For domestic household use only.
- Page 2 IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your product for the first time and keep them in a safe place.
- Page 3 IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance the cord away from traffic areas and where it will not be a tripping hazard. • This appliance must not be used in a bathroom. •...
- Page 4 Exposed to the Near water If the power cable weather outdoors wires are frayed or cut Where small children No extension leads or Where the power may be left unattended power boards cable may be damaged On a slope or Where there is risk Where it may be uneven surface...
-
Page 5: Specifications
Specifications Model no. DHPH20F Power supply 220-240V~50-60Hz Rated power 1800W Heat settings Thermostat Wall mountable Castors Tilt Switch Timer Turbo Fan Weight (net) 3.8kg Dimensions (w x d x h) 651 x 89.4 x 504mm For greater precision, please always refer to the rating label placed on the product. - Page 6 Parts Grille Feet Controls Low Heat High Heat...
- Page 7 Assembly 1. Place the unit upside down and remove the pre-installed screws on the bottom of the unit. 2. Insert each foot into the opening slots, ensuring they align correctly. 3. Place the screws back into position through the holes in the foot, and tighten to secure to the unit.
-
Page 8: Operation
Operation Note: Before plugging in for use, ensure the thermostat is set anti-clockwise to the MIN setting, and the heater switch is set to OFF. 1. Rotate the thermostat completely clockwise, until it reaches the MAX position. 2. To turn on the heating function, set the controls to your desired heat setting, either LOW HEAT or HIGH HEAT. -
Page 9: Safety Features
Positioning Select the position for the heater ensuring there is clearance from any furniture and fittings of at least 300mm each side. The heater should only be operated on a flat stable surface. NOTE: The Panel heater is designed for operation on an AC electricity supply, and is only suitable for domestic use and similar indoor locations. - Page 10 Cleaning WARNING - ALWAYS DISCONNECT THE POWER SUPPLY BEFORE CLEANING THE HEATER. • Do not use detergents, abrasive cleaning powder or polish of any kind on the body of the panel heater. • Allow the panel heater to cool, then wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean off any marks.
-
Page 11: Maintenance
Warranty Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below. Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd 8 Lakeview Drive, 38 Harris Road, East Tamaki,... - Page 12 Supplied by Glen Dimplex Australia 8 Lakeview Drive, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.