WARNINGS AND PRECAUTIONS Warnings Never place the unit near gas appliances, flames or flammable liquids. Never hit or shake the unit. Doing so may cause damage. Never cover or obstruct the air inlet or outlet. Doing so may cause overheating. ...
Page 4
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
STRUCTURE 1. Touch control 2. Silver circle 3. Display panel 4. Front grille 5. Front cover 6. Back filter cover 7. Filter 8. Water tank nut 9. Water tank 10. Back cover plug 11. Mist output nozzle 12. Back cover 13.
OPERATION DISPLAY PANEL Power indicator Temperature indicator ECO function indicator Timer indicator High power indicator Swing indicator Low power indicator...
Page 7
CONTROL PANEL REMOTE CONTROL ON/OFF button Timer/temperature set button Mode button Timer/temperature button Swing button HUMIDIFIER INDICATORS Indicator light Dial to adjust mist output...
Page 8
PRODUCT ASSEMBLY 1. Remove the unit from the packaging. There are 3 x parts – the main body, base & remote control. 2. Insert the base into the main body, and secure with the 2 wing nuts provided. 3. Place the unit upright on an even stable surface. Base Main body Wing nuts...
Page 9
Power or ECO mode depending on your needs. The unit automatically starts in LOW Power mode. SWING The unit will begin to oscillate after pressing the SWING button, and the indicator light will illuminate. To turn off the SWING function, press the swing button again, and the swing will stop and the indicator light will switch off.
Page 10
REMOTE CONTROL The remote control can be used to operate all functions. 1. Remove the battery cover at the back of remote control (Picture 2. Insert the battery (included) [Picture 3]. 3. Replace the battery cover. Operation 1. Connect the unit to a power supply and switch on. 2.
7. Press the Timer/Temperature button twice to set the temperature. The numbers will flash on the LED display when the temperature is ready to be set. The temperature can be set between 5-35°C. Press the ‘+/-’ buttons to set the desired temperature. 8.
Page 12
3. It’s important to clean the filters regularly. Gently wash the filter in mild, soapy water, dry and replace. Be sure to re-fit the rear screen securely. No special tools are required for this. 4. The water tank will need regular cleaning, especially in hard water areas.
The warranty period is 12 months from the date of purchase. For service advice, please contact the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Glen Dimplex Australia Pty Ltd Glen Dimplex Australasia Ltd 1340 Ferntree Gully Road,...