Only use SFP transceivers approved by Siemens for RUGGEDCOM products. Siemens
accepts no liability as a result of performance issues related in whole or in part to
third-party components.
4.4
GBIC Optic Ethernet Ports
GBIC (Gigabit Interface Converter) optic Ethernet ports are available with SC
(Standard or Subscriber Connector) connectors.
1
1
2
Figure 4.9
4.4.1
Installing a GBIC Optical Port
To install a GBIC optical port, do the following:
Electrical hazard – risk of damage to equipment
Use only components certified by Siemens with RUGGEDCOM products. Damage
to the module and device may occur if compatibility and reliability have not been
properly assessed.
Electrical hazard – risk of damage to equipment
Make sure all electrostatic energy is dissipated before installing or removing
components from the device. An electrostatic discharge (ESD) can cause serious
damage to the component once it is outside the chassis.
Only install GBIC optical ports that are compatible with the RUGGEDCOM RSG2100.
1.
RUGGEDCOM RSG2100
Installation Manual, 11/2022, C79000-G8976-1040-20
NOTICE
Tx Connector
Rx Connector
SC Port
NOTICE
NOTICE
NOTICE
Make sure all potential electrostatic build-up has been properly discharged to
prevent electrostatic discharges (ESD). This can be accomplished by wearing an
ESD-preventive wrist strap connected to either the chassis ground connector or a
bare metal surface on the router/switch.
4.4 GBIC Optic Ethernet Ports
2
Communication Ports
27