2.3.3 Mounting The Device To A Panel - Siemens SIMATIC NET RUGGEDCOM RSG2100 Installation Manual

Installing the Device
2.3.3 Mounting the Device to a Panel
2.
2.3.3 Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RSG2100 can be equipped with panelDIN
rail adapters pre-installed on each side of the chassis. The adapters allow the device
to be attached to a panel using screws.
To mount the device to a panel, do the following:
1.
12
2
3
Panel/DIN Rail Adapter
1
DIN Rail
2
Screw
3
Figure 2.2 DIN Rail Mounting
Install one of the supplied screws on either side of the device to secure the
adapters to the DIN rails.
Place the device against the panel and align the adapters with the mounting
holes.
RUGGEDCOM RSG2100
Installation Manual, 11/2022, C79000-G8976-1040-20
1
3
2