Gbic Optic Ethernet Ports; Installing A Gbic Optical Port - Siemens RUGGEDCOM RSG2200 Installation Manual

RUGGEDCOM RSG2200
Installation Guide
SFP Transceiver
RUGGEDCOM SFP1132-1LX70
RUGGEDCOM SFP1132-1LX100
RUGGEDCOM SFP1132-1LX115
a
MM = Multi-Mode, SM = Single-Mode
b
The RUGGEDCOM RSG2200 supports only 100/1000 Mbit/s.
Section 4.4

GBIC Optic Ethernet Ports

GBIC (Gigabit Interface Converter) optic Ethernet ports are available with SC (Standard or Subscriber Connector)
connectors.
Figure 20: SC Port
1. Tx Connector 2. Rx Connector
CONTENTS
• Section 4.4.1, "Installing a GBIC Optical Port"
• Section 4.4.2, "Removing a GBIC Optical Port"
Section 4.4.1

Installing a GBIC Optical Port

To install a GBIC optical port, do the following:
CAUTION!
Electrical hazard – risk of damage to equipment. Use only components certified by Siemens with
RUGGEDCOM products. Damage to the module and device may occur if compatibility and reliability
have not been properly assessed.
CAUTION!
Electrical hazard – risk of damage to equipment. Make sure all electrostatic energy is dissipated before
installing or removing components from the device. An electrostatic discharge (ESD) can cause serious
damage to the component once it is outside the chassis.
GBIC Optic Ethernet Ports
Order Code
6GK6000-8FG54-0AA0
6GK6000-8FG55-0AA0
6GK6000-8FE56-0AA0
1
Speed
a
Mode
(Mbit/s)
1000 SM
1000 SM
1000 SM
2
Chapter 4
Communication Ports
Nominal Distance (km)
70
100
115
25