Guidance Notes - Bay Networks CLAM Release Note

119781-B Rev. 01
The sections that follow offer guidance notes on the use of the
Nautica Clam and Marlin running 4.123R software. For
additional information on using your Nautica router with ISDN,
refer to the "Additional Information for use with ISDN" section in
the relevant Installation manual.
1. The BootP Relay function is designed only to forward DHCP
traffic, which happens to use a message format similar to
BootP. It should be noted that the current implementation is
not designed to forward regular (non-DHCP) BootP
messages.
2. If Nautica Wizard appears to get no response from the unit,
retry the operation.
3. It should be noted that although Bridge Control Protocol
(BCP) is implemented in this release, it is not recommended
that bridging be configured over ISDN only connections as,
due to the nature of bridged traffic protocols, ISDN lines
might be kept open permanently.
4. To enable Network Address Translation (NAT) from Nautica
Wizard, there are two options:
Chapter 3

Guidance Notes

3-1