Toro Greensmaster e1021 Diagnostic Manual page 41

1. Verify that the key switch is in the O
2. Disconnect the battery. Refer to
3. Locate the TEC-2402 controller
1. Harness connector P01
2. Harness connector P02
4. Use a multimeter and measure the resistance between the following pairs of locations:
Location Harness
1 Main
2 Main
1 Main
2 Main
1 Main
2 Main
position.
FF
Connecting and Disconnecting the Battery (page
(Figure 29) and unplug harness connectors P01 and P02
Connector Pin
J03 N/A
P01 6
J05 N/A
P01 3
J04 N/A
P02 1
Figure 31
3. TEC-2402 controller
Wire Expected
Color Reading
Tan
Less than
2 ohms
Tan
Gray
Less than
2 ohms
Gray
Violet
Less than
2 ohms
Violet
41
14).
(Figure
Connector Graphic
Figure 30
Figure 30
Figure 30
31).
g365074