Configuring A Call Server Or Csv Connection - Nortel 1000 Administration Manual

Chapter 4 Voice Office Configuration Requirements
Specifying a Source for Phone IP-to-DN Mappings

Configuring a Call Server or CSV Connection

1
2
3
4
5
6
48 Application Gateway Administration Guide
The following one-time setup applies to all Voice Office applications.
To configure a call server or CSV connection:
Open the Administration Tool: From a web browser, enter the URL
https://AG_ipAddress:AG_adminPort.
Go to the Operation > Voice Office > IP Phone page.
Select the source to be used to map extensions (DNs) to IP addresses.
If you selected a call server, complete these fields for the signaling server. If
your site uses more than one signaling server, you specify just one
signaling server (which automatically obtains information from the other
signaling server).
Typical sites have one signaling server deployed. However, larger
Note
sites might have a primary and secondary signaling server or two
signaling servers that are load balanced.
The signaling server IP address and Telnet port.
a.
The customer number (used by the call server if it is configured for
b.
more than one customer). Customer Number defaults to "0".
The credentials for the call server and signaling server.
c.
If you selected CSV, complete these fields:
For CSV file requirements, see
Note
page 49.
The URL of the Web server where the CSV file resides (http://url).
a.
The credentials required to access the URL, if required.
b.
Choose a schedule for synchronizing the Application Gateway with the
signaling/call servers or a CSV file.
"CSV File Format Specifications,"