Static Route Example - Nortel 1000 Administration Manual

1
2
3

Static Route Example

To remove a static route:
In the Application Gateway Administration Tool, go to the Network >
Routes page.
In the Static Route Table, select the check box for each route that you want
to delete.
Click Remove Static Route.
Suppose the IP address of the interface 0 port on your Application
Gateway is 10.0.16.20 and there has been a request to access information
at 129.6.0.20, to which you currently have no path. You can create a static
route through the Ethernet port that is not set as your Application
Gateway default gateway, and out to the requested network address, as
shown.
The figure shows the following connections:
The interface 0 port (IP address 10.0.16.20) leads to the default
•
gateway (IP address 10.0.16.1), which connects to the rest of the
10.0.0.0 network.
Chapter 3 Network Connection Configuration
Application Gateway Administration Guide
Configuring Routes
33