Configuring The Ldap Connection - Nortel 1000 Administration Manual

3
4
5

Configuring the LDAP Connection

Note
Select the country of the Application Gateway location.
For correct dialing, the Application Gateway and the PCs that are
Note
running Smart Agent must be located in the same country and area
code.
Enter the area code for the Application Gateway location.
For some locations in Europe, the area code is the geographic area code
without the domestic dialing prefix.
Click Submit.
During Smart Agent installation, a user is prompted to enter a user name
and password. Smart Agent authenticates the credentials against LDAP.
The user name is also used to obtain the associated telephone number for
the user. When a user clicks a number to call it, the Application Gateway
sends a message to the user's phone.
The Application Gateway stores the user name entered during installation
in a registry file and automatically fills it in each time the user starts Smart
Agent.
The Application Gateway connects to an LDAP server. The Application
Gateway supports LDAP version 3. Supported LDAP directories include
Microsoft Active Directory, OpenLDAP, SunONE/iPlanet LDAP, and
Novell eDirectory.
If you also use the Voice Office Application Suite, the LDAP directories
that you set up on the Operation > Voice Office > Directory page do not
relate to Smart Agent operation. If Smart Agent will use a directory that
you configured on the Directory page, you will need to configure that
directory on the Call Server page as described in the following steps.
Chapter 9
Application Gateway Administration Guide
Smart Agent Configuration
Configuring Smart Agent
109