Table of Contents
Advertisement
66 Chapter 5 Using recovery mode
5
From the Web browser, enter the management IP address of the VPN Router 600.
The Recovery Diskette screen appears
you can perform the following tasks:
•
•
•
•
•
•
NN46110-308 02.01
On your console you can see the BIOS banner and the Nortel VPN Router
banner. Then, you observe the unit execute its power-on self-test. You can
press the switch anytime during the power tests. A momentary press is all that
is required. You do not need to hold the button down.
Note: After the console completes the power-on self-test, it displays the
message
Booting recovery image
Booting the recovery image takes approximately 40 seconds. After the
recovery image boots, the VPN Router 600 displays the welcome message,
the recovery image version, and a prompt for you to enter the administrator's
user name. At this point, you are in recovery mode.
Enter a management IP address, subnet mask, and gateway if they are not
already assigned. You do this from the console menu after logging in as an
administrator.
When the unit has a management IP address, you can manage the unit from
the Web interface.
Note: The switch marked FD is reserved for future use. Pressing this
switch has no effect.
Restore the factory default configuration or the backup configuration.
Reformat the hard disk of the VPN Router 600.
Apply a new software version to the VPN Router 600.
Perform file maintenance.
View the Event log.
Restart the system.
.
(Figure 19 on page
67). From this screen,
Advertisement
Table of Contents
