Nortel BCM200 Overview page 25

•
The installation sequence is a critical component of this minimal
configuration scenario. Nortel recommends that you wait a few minutes
between configuring and installing each device to allow each device to
complete the boot cycle.
Connecting network devices for a converged small site (mixed-vendor
environment)
Step
1
2
3
4
5
Small and Medium Business Solutions Overview and Configuration Guide
Copyright © 2006, Nortel Networks
.
Configuring a converged small site (mixed-vendor environment) 25
"Installation and configuration workflow for a converged small site
(mixed-vendor environment)" (page 26)
Action
Connect the WAN port of the third-party router to the Internet
provider.
Connect the BES100/200 to the LAN port on the third-party router.
Connect the BCM50 to one of the VLAN 1 LAN ports on the
BES100/200.
Connect BAP120s to PoE ports on the BES100/200 if PoE ports are
available. If not, connect BAP120s to LAN ports on the BES100/200.
If Guest Access is required, connect the BAP120s that supply
wireless Guest Access to one or more of the ports designated to
VLAN 2 (guest) on the BES100/200.
NN47910-200 02.01 Standard
Release 1.00 11/22/2006
—End—
SMB
Nortel Networks Confidential