Nortel 6140 Getting Started page 4

Getting Started
Your Nortel WLAN Handset 6120 and 6140 uses radio wave technology to
send and receive voice and data transmissions. It is designed to operate
much like a cell phone. However, the Handset uses the private communica-
tion system installed in your facility and will not operate outside the area
covered by this system.
The Handset's Battery Pack must be fully charged before its first use.
Place the Handset into the Charger for a minimum of two hours.
If you want to Then
Change the language Press the Cfg softkey to open the Config
Remove the Battery
Replace the Battery
Turn the Handset on Press and hold the END key until two chirps
4
Menu. Select Phone Settings and then select
the Language option. Use the Nav keys to
scroll to and select the desired language. The
handset menus will now display in the selected
language. Note: There is no language option
for Italian.
Press down on the latch on the Battery Pack at
Pack the back of the Handset and pull the Battery
Pack towards you. The Battery Pack releases
outward.
Slide the lip of the Battery Pack into the bottom
Pack of the cavity. Push the top of the Battery Pack
until it snaps into place. You should not have to
force it into the Handset.
sound.
English