Create A Radio Profile For Voice - Nortel 2350 User Manual

88 Configuring Wireless Services
• Click Next. Type a passphrase from 8 to 63 characters long in the Pre-shared Key box and
click Generate.
• Click Next. Type voice-vlan as the VLAN name to place voice users in.
• Click Next. (If the device supports WMM, select WMM.)
• Click Next. Select RadioProfileVoic in the Radio Profiles list.
• Click Finish.
3
Set up a VLAN on the WSSs.
• From the Create VLAN wizard, enter voice-vlan as the VLAN name.
• Click Next. Select the VLAN ports. Click Move to use them exclusively in this VLAN.
• Click Finish.
• Select the VLAN and click Properties.
• Select IGMP and deselect Enabled to disable IGMP snooping.

Create a Radio Profile for Voice

This procedure is similar to the procedure in
delivery traffic indication map (DTIM) interval to 3.
To create a radio profile for voice service
1
Select Configuration on the toolbar.
2
In the Organizer panel, expand the WSS.
3
Expand Wireless, then select Radio Profiles.
4
In the Task List panel, select Radio Profile.
The Create Radio Profiles wizard is displayed.
5
Enter the name of the radio profile (for example, RadioProfileVoic), then click Next at the bottom of the
wizard.
6
If APs are already configured, select the radios to map to the radio profile, then click Move.
WLAN Management Software removes the radios from the radio profile they are in and places them in
the new profile.
If you have not configured the APs in WLAN Management Software yet, no radios are listed. You can
map the radios to the radio profile later.
7
Click Finish to save the changes and close the wizard.
The new radio profile appears in the Content panel.
8
If you are configuring voice service for SpectraLink devices, perform the following steps:
a
Select the radio profile in the Radio Profiles table and click Properties.
b
Click the 802.11 Attributes tab.
c
In the DTIM Period box, change the value to 3.
d
Click OK.
NN47250-101 (320665-G Version 02.01)
"Create a Radio Profile" on page 57, but has additional steps to change the