Installing The Left Midplane - Dell PowerEdge C6600 Installation And Service Manual

Next steps
Replace the left midplane

Installing the left midplane

Prerequisites
NOTE: You must route the cables properly on the chassis to prevent them from being pinched or crimped.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove all the sleds from the
4. Disconnect all the cables, except the power cables.
Steps
1. Using the Phillips 2 screwdriver, connect and secure the left power cables to the midplane.
Figure 50. Connect the left midplane power cables to the midplane
2. Route the power cable through the cable clip on the chassis, and slide the midplane to the chassis by hooking the left
bracket.
3. Using the Phillips 1 screwdriver, install the screws securing the midplane to the chassis.
4. Using the Phillips 2 screwdriver, secure the left power cables to the chassis management board.
52 Installing and removing system components
Safety instructions.
Before working inside your
enclosure.
system.