Table of Contents
Advertisement
Figure 84. Installing the left examax connector
Next steps
1.
Install the 60 mm cooling fan
2. Follow the procedure listed in
Drive cage
This is a service technician replaceable part only.
Removing the drive cage
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before
removing the backplane.
CAUTION:
You must note the number of each drive and temporarily label them before removal so that you can
replace them in the same locations.
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
NOTE:
Drive cage removal steps are the same for all configurations.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the system
cover.
4.
Remove the mid top
cover.
5. If applicable, disconnect the backplane and expander board cables from the linking board and chassis management board.
6.
Remove the drive
carrier.
cage.
After working inside your
Safety
instructions.
system.
Installing and removing system components
81
Advertisement
Table of Contents
