Table of Contents
Advertisement
Figure 65. Removing the right control panel assembly
Next steps
Replace the right control
Installing the right control panel
Prerequisites
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system.
NOTE:
Additional tape maybe required to secure the cables.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the mid top
cover.
4.
Remove the 80 mm
fans.
5.
Remove the diskless 80 mm fan
6. Disconnect control panel cables from the midplane.
Steps
1. Route the right control panel cable through the cable retention clips and the rubber holder on the right midplane.
2. Align and install the left control panel assembly.
3. Using the Phillips 1 screwdriver, tighten the screws to secure the control panel to the system.
NOTE:
You must route these cables properly when you replace them to prevent the cables from being pinched or
crimped.
panel.
Safety
instructions.
Before working inside your
cage.
system.
Installing and removing system components
65
Advertisement
Table of Contents
