Table of Contents
Advertisement
Figure 33. Installing the diskless 80 mm fan cage
Next steps
Follow the procedure listed in
Removing the 60 mm cooling fan cage
Prerequisites
WARNING:
Do not attempt to operate the system without the cooling fans.
WARNING:
The cooling fan spins for some time after the system is powered down. Allow the fan to stop
spinning before removing it from the system.
NOTE:
Observe the routing of the cables when removing them from the system. Route these cables properly when you
replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the system
cover.
4.
Remove the mid top
cover.
Steps
1. Disconnect the fan power cable from the chassis management board.
2. Lift the cooling fan cage out of the chassis.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
37
Advertisement
Table of Contents
