Workport Device Configuration; Dhcp Status - SonicWALL TELE3 TZ Getting Started Manual

5.Enable Block traffic through tunnel when IP spoof detected if your network
administrator asks you to enable the service.
6.Enable the Obtain temporary lease from local DHCP server if tunnel is down check
box if your administrator asks you to enable the service. Enter the number of minutes for the
temporary lease in the Temporary Lease Time box.

WorkPort Device Configuration

7.To configure Static Devices on the WorkPort, enter the IP address of the device in the
IP Address field. Then enter the Ethernet Address of the device in the Ethernet Address
field.
8.Select WorkPort Devices not allowed to obtain IP through SA if there are devices on
the WorkPort that you do not want to obtain IP addresses through the VPN tunnel. The
Ethernet address of a device can be determined by typing
Prompt window.
If a you have has trouble connecting to a central gateway and obtaining a lease,
Note:
verify that Deterministic Network Enhancer (DNE) is not enabled on your PC. Check with
your network administrator to verify your network settings.

DHCP Status

A Status page is now available to review DHCP Server Status and DHCP over VPN Status.
The DHCP Server Status section reports the number of Current, Available Dynamic,
Available Static leases as well as the Total leases. The DHCP over VPN Status section
reports the number of Current Dynamic, Current Static, and the Total leases.
Page 28
ipconfig/all
into a Command