Installing The Sonicwall - SonicWALL TELE3 TZ Getting Started Manual

Installing the SonicWALL

Reminder: Before you begin your SonicWALL installation, contact your ISP and obtain your Internet
connection information. Enter this information into Section 4. Next, place your SonicWALL on a
hard, flat surface near your cable modem, DSL modem, or Internet router.
Apply Power to the TELE3 TZ
1
Attach the power supply to the power cord. Plug the power input into the SonicWALL and
the other end into a power outlet.
WorkPort
Connect the SonicWALL to the Internet
2
Connect the SonicWALL WAN port to your cable modem, DSL modem, or Internet
router using the grey Ethernet cable. The Link LED should light up indicating a
connection. If it does not light, use the red crossover cable to establish a connection.
The two cables can be interchanged without damage to the SonicWALL or your
computer.
Connect the SonicWALL to Your WorkPort
Connect the red crossover cable to the SonicWALL WorkPort. Connect the other end
to your work computer at the network port. The WorkPort link LED should light up
indicating a connection. If the Link LED does not light, try the grey Ethernet cable.
Connect Your Computer to the HomePort
Connect your home PC to the
grey Ethernet cable. If the Link LED does not light, try the grey Ethernet cable.
HomePort
using either the red crossover cable or the
HomePort
WAN
SonicWALL Telecommuter's Getting Started Guide Page 11
Power