Check Link Leds; Network Addressing Information - SonicWALL TELE3 TZ Getting Started Manual

Check Link LEDs

If a Link LED does not light after connecting a cable, try connecting the ports using the
3
other cable in the box. For instance, if you used the grey Ethernet cable to connect the
WAN port to the cable modem, DSL modem, or your Internet router and the Link LED does
not light, try connecting the red Crossover cable to the ports.
WAN Link LED
The SonicWALL Test LED stays lit when the SonicWALL is powered on initially. It stays lit
while the SonicWALL performs a series of diagnostic tests. After verifying the Link LEDs,
power off the TELE3 TZ or TELE3 TZX for a few seconds, then power it up again to cycle the
TELE3 TZ or TELE3 TZX.

Network Addressing Information

In order to continue the installation of your SonicWALL, you need to obtain IP addressing
4
information from your Internet Service Provider (ISP). The information is required to connect
to the Internet.
ISP Contact Information
Telephone Number, if contact by phone__________________ or e-mail address if you
contact your ISP via e-mail_________________________.
You will use one of the following connection types to connect to the Internet:
Static IP Address
IP Address________________
Subnet Mask______________
Default Gateway:__________
DNS Address:______________
Page 12
HomePort
Link LED
NAT with PPPoE
User Name:_______________
Password:_________________
WorkPort
Link LED
NAT with DHCP
Host Name:___________________
MAC Address (SonicWALL Serial
Number):_____________________
Domain Suffix:_________________
Test
Light