SonicWALL TELE3 TZ Getting Started Manual page 19

DHCP Server Disabled
B
If you did not enable the SonicWALL DHCP server, a window with configuration instructions
is displayed:
After the SonicWALL has restarted, change the network settings on the computers located on the
WorkPort. Configure each computer with a static IP address from the range displayed in your
configuration instructions.
You may need to restart the computers on your network to update the network settings.
The SonicWALL is now functioning and protecting your network from Internet-based attacks and
break-ins.
Page 18
!
On a Windows 2000 computer, do the following:
1. From the Start menu, select Settings.
2. Then select Network and Dial-up
Connections.
3. Right click on the Local Area Connection
icon, and then select Properties.
4. Click Internet Protocol (TCP/IP) and then
Properties.
5. Select Use the following IP address and
enter an IP address from the range indicated in
your Wizard restart screen.
6. Enter the subnet mask indicated in your Wizard
restart screen in the Subnet Mask field.
7. Enter the Default Gateway IP address in the
Gateway field.
8. Enter IP addresses of the DNS servers provided
by your ISP.
9. Click OK, then OK again to close the
Properties window.
Print this screen. You
need the information to
configure computers on
your WorkPort.