Configuration Guide - Grandstream Networks HT813 Administration Manual

LED Lights Status
The FXS LEDs indicate status of the respective FXS/FXO port-phone on the back panel
OFF – Unregistered
FXS/FXO LED
ON (Solid Blue) – Registered and Available
Blinking every 500 ms – Off-Hook / Busy
Slow blinking – FXS LEDs indicates voicemail

CONFIGURATION GUIDE

The HT813 can be configured via one of two ways:
The IVR voice prompt menu.
The Web GUI embedded on the HT813 using PC's web browser.
Obtain HT813 IP Address via Connected Analogue Phone
HT813 is by default configured to obtain the IP address from DHCP server where the unit is located. To know which IP address
is assigned to your HT813, you should access to the
phone and check its IP address mode.
Please refer to the steps below to access the interactive voice response menu:
1. Use a telephone connected to FXS port of your HT813.
2. Press *** (press the star key three times) to access the IVR menu and wait until you hear "Enter the menu option ".
3. Press 02 and the current IP address will be announced.
Understanding HT813 Interactive Voice Prompt Response Menu
The HT813 has a built-in voice prompt menu for simple device configuration which lists actions, commands, menu choices,
and descriptions. Connect analog phone to FXS port. Pick up the handset and dial "***" to use the IVR menu.
Menu Voice Prompt
Main "Enter a Menu
Menu Option"
"DHCP Mode",
01 "Static IP Mode"
"PPPoE Mode"
Table 4: HT813 LEDs Pattern Description
"Interactive Voice Response
Options
Press "*" for the next menu option
Press "#" to return to the main menu
Enter 01-05, 07,10, 12-17,47 or 99 menu options
Press "9" to toggle the selection
If using "Static IP Mode", configure the IP address information using menus 02 to 05.
If using "Dynamic IP Mode", all IP address information comes from the DHCP server
automatically after reboot.
If using "PPPoE Mode", configure PPPoE Username and Password from web GUI to get IP from
your ISP.
Menu" of your adapter via the connected