Heated Seats - If Equipped - Jeep GRAND CHEROKEE 2023 Owner's Manual

H S — I E
EATED EATS F QUIPPED
WARNING!
 Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabetes,
spinal cord injury, medication, alcohol use, exhaus-
tion or other physical condition must exercise care
when using the seat heater. It may cause burns even
at low temperatures, especially if used for long
periods of time.
 Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cushion.
This may cause the seat heater to overheat. Sitting in
a seat that has been overheated could cause serious
burns due to the increased surface temperature of
the seat.
Front Heated Seats
The front heated seats control buttons are
located on the center stack below the radio
screen or within the Uconnect system. You can
gain access to the control buttons through the
Comfort screen.
 Press the heated seat switch once to turn the HI setting
on.
 Press the heated seat switch a second time to turn the
MED setting on.
 Press the heated seat switch a third time to turn the
LO setting on.
 Press the heated seat switch a fourth time to turn the
heating elements off.
NOTE:
 Once a heat setting is selected, heat will be felt within
two to five minutes.
 The engine must be running for the heated seats to
operate.
 The level of heat selected will stay on until the operator
changes it.
GETTING TO KNOW YOUR VEHICLE
Rear Heated Seats
The two second row outboard seats may be
equipped with heated seats. There are two
heated seat switches that allow the rear
passengers to operate the seats
independently. The heated seat switches for each heater
are located on the rear of the center console.
You can choose from HI, MED, LO, or OFF heat settings.
Indicator lights in each switch illuminate indicating the
level of heat in use.
 Push the heated seat switch once to turn the HI setting
on.
 Push the heated seat switch a second time to turn the
MED setting on.
 Push the heated seat switch a third time to turn the
LO setting on.
 Push the heated seat switch a fourth time to turn the
heating elements off.
The level of heat selected will stay on until the operator
changes it.
NOTE:
The engine must be running for the heated seats to
operate.
41