Turning Active Lane Management On Or Off - Jeep GRAND CHEROKEE 2023 Owner's Manual

146 STARTING AND OPERATING
When both lane markings are detected, and the driver
uses the turn signal to indicate a lane change, and a
vehicle is detected in the BSM zone on that side of the
vehicle, the ALM system provides a warning in the form of
steering assist and/or steering vibration (depending on
radio settings) to guide the vehicle back to the center of
the lane.
NOTE:
 The system will suppress visual warnings, steering
vibration (if selected in radio settings), and steering
assistance (if selected in radio settings) when the
driver activates the turn signal, the blind spot zone is
clear of vehicles, and a lane change is occurring.
 If the Blind Spot Monitoring (BSM) system detects a
vehicle in the adjacent lane, and the turn signal is
applied in that direction, the BSM LED on the mirror will
flash. If the driver continues to attempt the lane
change, steering wheel torque will be provided to keep
the vehicle within its lane markings.
The driver may manually override the steering assist
warning by applying force to the steering wheel at any
time.
When only a single lane marking is detected and the driver
drifts across the lane marking (no turn signal applied), the
Active Lane Management system provides a visual
warning in the instrument cluster, as well as a steering
assist torque (if configured in Uconnect Settings), to
prompt the driver to remain within the lane boundaries.
If the driver continues to drift out of the lane, the system
provides a flashing visual warning through the instrument
cluster display as well as a haptic steering wheel vibration
(if configured in Uconnect Settings) when the vehicle
crosses the lane boundary.
NOTE:
When operating conditions have been met, the Active
Lane Management system will monitor if the driver's
hands are on the steering wheel and provides an audible
and visual warning to the driver if removed. The system
will cancel if the driver does not return their hands to
the wheel.
T A L M
URNING CTIVE ANE ANAGEMENT
O O O
N R FF
The Active Lane Management button is located
on the switch panel above the Uconnect
display.
To turn the system on, push the Active Lane Management
button (LED turns off). A message is shown in the
instrument cluster display.
To turn the system off, push the button twice
(LED will turn on).
NOTE:
If the button is only pressed once, a pop-up will appear in
the instrument cluster display instructing the driver to
press the button again to disable the system.