Newco Gevalia User Manual page 18

Water or coffee has leaked into the base
tray of the machine, either from the
capsule bin area or from the workings of
the machine itself.
Switch off the machine.
Open the door and remove the capsule
bin. Thoroughly dry the base tray using
absorbent paper towels. Pay particular
attention to the spill sensor, and dry it
thoroughly. Switch the machine on and it
will reset automatically.
If the fault recurs, and fresh clear water
is seen in the base tray area, disconnect
the machine from the power supply and
close the water tap.
Call a Technical Service Representative.
O P E R A T O R ' S
There is a capsule in the entry flap
of the brew mechanism, or the
capsule entry flap is stuck open.
Remove the capsule from the entry
flap, or if the capsule entry flap is
stuck open, switch off the machine,
open the front door, and remove the
clamp assembly (see 'Cleaning the
Clamp Assembly' on page 8). Clear
away any obstacle holding the
capsule entry flap open and pull the
entry flap forward until it is in the
closed position. Reassemble the
clamp and close the door.
Switch on the machine to revert to
normal operation.
or
* may be any number from 1 - 9.
Switch off the machine, remove the
clamp, clear any jammed capsules
and replace the clamp.
Switch on the machine.
If the problem persists, call a
Technical Service Representative.
H A N D B O O K