Newco Gevalia User Manual page 14

With the clamp plate assembly removed, the
clamp plate should be thoroughly cleaned,
paying particular attention to ensure that the
cutting teeth are clean.
If necessary the lower clamp plate can be split
to allow more thorough cleaning; simply push
in the two plastic lugs (fig. iii A) and the clamp
plate should unclip.
To re-assemble, push in the two plastic lugs
and snap the clamp plate back into position.
Whilst the clamp plate assembly is removed from the machine, look underneath the brewing
mechanism on the machine, and clean the underside of the brewing mechanism.
To replace the clamp plate assembly after
cleaning, look underneath the machine to
locate the hinge grooves (fig. iv A) either side
of the brewing mechanism. Holding the clamp
plate assembly in the palm of your hand, at
an angle of 45°, align the clamp plate hinges
(fig. iv B) with the hinge grooves and slide
the assembly backwards, whilst still holding
the clamp plate assembly at 45°, until it drops
on the hooks (fig. iv C). The clamp assembly
will swing freely if it is correctly located.
fig. v
A
A
C
fig. iv
B
Close the mechanism by placing your forefinger
behind the tab on the clamp plate assembly and
raising it upwards, towards you. With the clamp
plate in the 'up' position, place your thumb on the
latch and, whilst keeping your forefinger behind
the tab on the clamp plate assembly, snap the latch
shut (fig. v). Close the door and switch on the
machine.
fig. iii
A
9