Ipx Parameters (Default Profile) Screen; System Configuration Screens - Netopia R7100-C User Reference Manual

IPX parameters (default profile) screen
The IPX Parameters (Default Profile) screen allows you to configure various IPX parameters for DSL connections
established without an explicitly configured connection profile:
NetBios Packet Forwarding:
Path Delay:
Incoming Packet Filter Set...
Outgoing Packet Filter Set...
Incoming SAP Filter Set...
Outgoing SAP Filter Set...
Periodic RIP Timer:
Periodic SAP Timer:
For details on setting up IPX Parameters see
"Security" on page 13-1.
System configuration screens
You can connect to the Netopia R7100's system configuration screens in either of two ways:
By using Telnet with the Router's Ethernet port IP address
Through the console port, using a local terminal (see
page 6-3)
You can also retrieve the Netopia R7100's configuration information and remotely set its parameters using the
Simple Network Management Protocol (see
Open a Telnet connection to the router's IP address; for example, "192.168.1.1."
IPX Parameters (Default Profile)
"IPX Setup" on page
"SNMP" on page
WAN and System Configuration 8-5
Off
10
<<NONE>>
<<NONE>>
<<NONE>>
<<NONE>>
60
60
10-1. For details on setting up Filter Sets see
"Connecting a console cable to your router" on
12-12).